JMicron Gigabyte RAID support

[JohnM]

Hello,
first of all let me say that this is a great piece of software.
But my problem is with the JMicron / Gigabyte RAID support. On the webpage it is stated that Sentinel in version 3.50 supports JMB36X RAID controllers.
I have such a controller on a Gigabyte board, the problem is that I only see one hard disk from that RAID array (it has 2 disks, Stripe configuration).
The other disk is not in the drive list at all. This can't be right, can it? I can supply debug data if needed.
Cheers,
John

[hdsentinel]

As you may notice on the website, not only version 3.50 is required, but this should work "With latest drivers from the Driver Zone section".
Do you use the driver installed for the RAID controller? You may try the GBB36X / JMB36X driver for your controller.
Please use Report menu Send test report to developer option as it can help to diagnose the issue.

[JohnM]

Thanks, that did the trick. After installing the latest driver both disks from the RAID show up.
Cheers,
John

[hdsentinel]

Thanks!