Thanks, I see!
4.10 was too old for these newer controllers, generally newer versions required for newer hardware in order to support them.
Yes, from the new report I see the situation: when the controller accessed, it responds with generic information only but there is no real details about the drives. Really weird, as with SAS9300-8i tested, there were no such problems / issues.
Not sure, but it is possible that the problem may be related to backplane / SAS expander used for the SATA hard disks, as this may block accessing the disk status information. Do you use any special such SAS explander / backplane?
Trying to perform further researching about the possibilities....
Thanks for your attention, I'll let you know any new, updates!