Support for IDE/SATA Controllers in Raid 0/1 Mode

Experiences with hard disks, SSDs, USB devices, hard disk controllers, motherboards and so.

Support for IDE/SATA Controllers in Raid 0/1 Mode

Postby onlap » 2010.09.23. 13:37

Support for IDE/SATA Controllers in Raid 0/1 Mode

Thanks ;)
onlap
 
Posts: 1
Joined: 2010.09.23. 13:33

Re: Support for IDE/SATA Controllers in Raid 0/1 Mode

Postby hdsentinel » 2010.09.23. 16:06

There are many RAID controllers supported and disk information detected when the disks are in RAID configuration.
For example on NVidia, Silicon Image controllers (just the simpler ones) and LSI / HighPoint / Areca / 3ware / AMCC.
These are listed in the "RAID Controllers" section at the top of http://www.hdsentinel.com/compatibility_disk_controllers.php

Just make sure to use proper (recent) driver versions ;)
User avatar
hdsentinel
Site Admin
 
Posts: 2334
Joined: 2008.07.27. 17:00
Location: Hungary

Re: Support for IDE/SATA Controllers in Raid 0/1 Mode

Postby klauzser » 2012.11.06. 05:25

Checking updates from time to time won't actually hurt, right?
User avatar
klauzser
 
Posts: 24
Joined: 2012.10.31. 02:47

Re: Support for IDE/SATA Controllers in Raid 0/1 Mode

Postby hdsentinel » 2012.11.06. 12:07

Be careful - not always the latest driver is the best.
On Support -> Driver Zone page the tested and verified drivers listed. Some controllers (eg. Marvell, Intel) may have different/updated drivers - but they are worse.

klauzser wrote:Checking updates from time to time won't actually hurt, right?
User avatar
hdsentinel
Site Admin
 
Posts: 2334
Joined: 2008.07.27. 17:00
Location: Hungary


Return to Supported Hardware

Who is online

Users browsing this forum: No registered users