Hard Disk Monitoring

I have HD Sentinel set up to send me a daily status email. So far all my connected drives (between 3 and 5) are running at 100%, and the subject header of the daily status email always says "...[100%]". But I'm not sure if the percentage in the subject header is an average of all the drives, or just reporting on drive 0.

If any of the drives starts reporting a value less than 100%, will the daily status email's subject header report something other than 100%, regardless of which drive has the problem? Or will I need to sift through the verbose report to see if any values are less than 100%? I also have separate alerts set up in case the values drop below 100%, but I'm wondering specifically about the subject header of the daily status email.

The subject of the daily status e-mail shows the LOWEST health of all drives.
Designed exactly to show immediately if the health of any disk drive decrases. This way you do not need to scroll the report, as the subject immediately shows the value.
100% ? Then there are no problems

Good to know, thanks!